Throttle cable manifold sets for Dell'Orto carburettors with M6 thread in the carburettor cap.

We carry the manifolds with different angles, so you can rebuild the carburetors for almost every installation position. Usually the Dell'Orto carburettors are delivered with a short set screw directly screwed into the carburettor, or they have a 70°-90° angled connector.

For some installation positions, like the Smallframe models ala Primavera, ET3, PK etc., it is useful to convert the existing throttle cable manifold. Here the throttle cable is led from below to the carburettor, therefore the 180° elbow is ideally suited here.

This should however only be carefully countered to avoid a vibration break due to the large span of the elbow.

  • 50°
  • 70°
  • 90°
  • 180°

Included is the elbow, the adjusting screw for the throttle cable clearance, as well as the rubber grommet for the outer cable, which should prevent dirt and water from entering.

TIP: Also suitable for Keihin PWK carburettors!

Malossi 180 degree Carb Throttle Cable Guide fits all carbs with 6mm adjuster